TriPollar STOP Vx GOLD 2

The Ultimate Skin Innovation is Coming

Why choose when you can have the best features all in one device?

The TriPollar STOP VX GOLD combines the power of Multi-RF and DMA technologies to reshape your facial features and smooth the skin.

Multi-RF Technology uses interchanging Radio Frequency waves, evenly distributing heat in the dermis layer to stimulate collagen and elastin fibers production. This smooths the skin to reduce wrinkles and fine lines.

DMA Technology targets muscles to improve muscle tone. This technology targets different layers of the muscles, effectively increasing muscle density and volume long-term.

Thanks to these two innovative technologies working in sync, the TriPollar STOP VX GOLD provides amazing results that reshape and tone facial features such as the jawline contour, plump and tighten sagging skin, while reducing wrinkles. You can achieve optimal and immediately visible results in the comfort of your own home.

This cutting-edge device provides extraordinary results. Combining Multi-RF and DMA technologies, its next-generation treatment tightens the skin, visibly reducing the appearance of fine lines and wrinkles while improving muscle toning to define the jawline contour. The TriPollar Stop VX achieves optimal results by using the two innovative technologies to reshape facial features and erase signs of aging.

• TriPollar STOP VX Gold Model
• User Manual + Quick Start Guide
• Power Supply (UK, EU and US Plug)
• TriPollar Preparation Gel, 1.7 FL OZ (50 ML)
• TriPollar Gold Preparation Gel, 1.7 FL OZ (50 ML)

Directions

• Cleanse and dry the face/neck area
• Apply a very thin layer of the TriPollar Preparation Gel over the entire treatment area (face and/or neck). This gel must be used during the entire treatment process.
• Turn the device ON by pressing the Power button. Make sure that the green indicator light turns ON.
• Select the power setting (Low/High) that is most comfortable.

• Divide the face in 3 treatment areas (Right Cheek, Left Cheek, Forehead)
• Place the device on the skin, make sure to apply a slight pressure in order to assure full contact between the electrodes and the skin.
• Move the device in a very slow circular motion on a small part of your treatment area, slowly heating your skin to the optimal temperature.
• Once the orange indicator light illuminates followed by a ‘beep’ sound, you have reached the optimal temperature. Continue the same slow circular motion for a few seconds, then gradually enlarge the movements in the treatment area.
• Continue working on the entire treatment area in slow circular motion for 4-5 minutes, and proceed to the next treatment area, repeating the above steps. Treatment can be augmented by “lifting” movements from the jaw line upwards toward your cheeks.
• Switch to RF + DMA mode (only use it on the jaw line area). It's recommended to start at the Low power level.
• Start moving the device using a very slow linear motions along the jaw line.
• To ensure optimal results, use the device for 5 minutes on each side. After the entire treatment area has been treated, the treatment session is complete.
• Press the Power button for two seconds to turn the device OFF.
• Gently remove the TriPollar Preparation Gel for skin and wash face.
• Clean the electrodes of the device with a damp cloth or paper towel and cover the device tip with its protective cover.